However, you??™ll have an easier time flying a camera through the logo??™s
elements if you make it a bit larger than this default size. You??™ll also notice some
serious jagged edges around the image.
4. In the Backdrop tab of the Display Options panel, change the Size to 5m from the
current 1m.
5. Change the Image Resolution to 2048. This will allow you to see the image clear
and sharp in the background.
Note
Changing the Image Resolution in the Display Options panel has nothing to do with
the actual resolution of the image or your 3D model. This is a display option only.
LightWave v9 allows display resolutions up to 4,096 pixels.
6. Bring the Brightness and Contrast down so that the backdrop image is not overpowering.
When you create 3D models, your points and polygons might be hard
(or impossible) to see if the backdrop image is excessively bright. So dim the
backdrop until you can just see it as a reference. Click OK and then press a to fit
the image into view. Figure 7.4 shows the results of the last three steps.
Figure 7.4 Increase the size and resolution of the background image while decreasing the
brightness and contrast gets the background image ready for modeling.
Pages:
404
405
406
407
408
409
410
411
412
413
414
415
416
417
418
419
420
421
422
423
424
425
426
427
428