Then, from
the Select drop-down menu at the top left of the interface, choose Select Loop.
The entire edge loop will be selected (Figure 8.23).
Figure 8.23 The Select Edge Loop option lets you quickly select an entire edge.
49. With the edge selected, press Ctrl+b to activate the Edge Bevel tool. Click and
drag to bevel the selected edge about 20mm or so (Figure 8.24).
Figure 8.24 Bevel the edge to add detail at the neck of the banana.
Inside LightWave v9 326
Chapter 8 Modeling Still-Life Objects 327
50. Select the outer edge of the banana tip, and bevel it as well (Figure 8.25).
Figure 8.25 Bevel the outer edge of the banana tip.
51. Using the right mouse button, lasso-select the points of the end of the banana,
and extend them about 180mm on the negative Z-axis, as shown in Figure 8.26.
Figure 8.26 Select the points around the end of the banana and move them out on the negative
Z-axis.
52. With the points still selected, change the Action Center to Mouse, using the
Modes drop-down list at the bottom of the interface. Then, press y to select the
Rotate tool. Click and drag slightly in the Top view, directly on the edge of the
selected points, to rotate the selection in a clockwise direction, about 15 degrees.
Pages:
451
452
453
454
455
456
457
458
459
460
461
462
463
464
465
466
467
468
469
470
471
472
473
474
475