Now, carefully select the very
bottom-left point of the box,
and holding the Shift key,
select the point immediately
above it, as shown in
Figure 14.13.
You??™re selecting two points
sequentially to tell Modeler
which way you want your selection
to go, for the next step.
7. So, from the Select drop-down
at the top left of the interface,
choose Select Loop, as shown
in Figure 14.14.
8. Once you choose Select Loop,
LightWave Modeler continues
selecting points for you around
the entire box, as shown in
Figure 14.15.
Figure 14.15 Using Select Loop is an easy way to select the points around the entire box.
Figure 14.13 Select in order, the bottom-left
corner point and the point just above it.
Figure 14.14 Choose Select
Loop to automatically continue
the selection of points.
9. With the entire outer edge of points selected, click the Modify
tab, and at the bottom left under the Transform category,
click the More drop-down button and then choose Quantize,
as shown in Figure 14.16.
10. In the Quantize dialog box, leave all axis settings at 500mm,
as shown in Figure 14.17. You can simply enter .5 and press
the tab key to get a 500mm setting.
Pages:
688
689
690
691
692
693
694
695
696
697
698
699
700
701
702
703
704
705
706
707
708
709
710
711
712