Inside LightWave v9 630
Chapter 15 Advanced Cameras and Rendering 631
Repeat this process and locate the Lscripts folder. That??™s the master computer setup (see
Figure 15.40)!
Figure 15.40 The Browse for Folder panel again, used for adding plug-ins.
To recap, you created two shortcuts to the LightWave Layout program. Each shortcut
pointed to a different set of config files, one for normal LightWave usage and the other
for ScreamerNet use.
You then copied the existing config files into the config_lightwave and config_screamernet
folders.When done, you loaded the version of LightWave pointing to the ScreamerNet
config files.
Next, you set up the content folder and the command folder, and rescanned the plug-in list.
This saved the network-aware pathnames for each item into the ScreamerNet config files.
Setting Up the Render Nodes
Setting up the nodes is relatively simple compared to setting up the master computer
because you can set up one node and then simply copy the same set of files to the other
nodes, changing only a few bits of information.
At this point, you need to decide whether your master computer itself is a render node.
Pages:
759
760
761
762
763
764
765
766
767
768
769
770
771
772
773
774
775
776
777
778
779
780
781
782
783