cd c:\lightwave\programs\
This line changes the current directory to the Programs directory on the main hard drive
so that the next line knows where to find the LWSN.exe program. If you installed
LightWave somewhere else, then change this line to reflect where you put it.
LWSN ??“2
This runs the LightWave ScreamerNet program. The ??“2 sets up which mode ScreamerNet
will run in. The ??“2 basically says you??™re accepting commands from the master computer
on which scene or frame to render. There is a ??“3 mode, which enables you to specify the
scene and the start/end frames, but this mode defeats the point of using several computers
to render a scene because ??“3 mode only enables you to pass it one scene. Basically,
you??™ll never need to use ??“3 mode!
??“c\\Dansboxx\screamernet\config_screamernet
This command tells LWSN.exe where the config files are kept on the network. The ??“c is
the switch that says the following text is the path to the config files. If you have your config
files elsewhere, now is the time to tell ScreamerNet where they are. Remember,
LWSN.exe needs to know the location of the config files in order to find the location of the
plug-ins, the paths to which are stored in the LWEXT9.
Pages:
763
764
765
766
767
768
769
770
771
772
773
774
775
776
777
778
779
780
781
782
783
784
785
786
787